Roof Replacement Cost in Louisville, Ohio
A roof is priced by its size, its pitch and what turns up under the old shingles. This page explains each of those for houses in Louisville, Ohio, and gives Northeast Ohio market ranges so you have a yardstick before anyone measures.
Quick facts
- What is included
- A written quote covers tear-off, underlayment, ice and water shield, drip edge, starter, ridge vent, architectural shingles, dumpster and cleanup.
- Typical time
- The quote follows the free inspection. The install itself commonly runs one to two days.
- Permits
- Louisville Planning and Zoning issues the reroofing permit. Its application shows a plans review fee, a city permit fee and a 1 percent state fee.
- How pricing works
- A single flat quote in writing that holds for twelve months. The dollar figures on this page are market ranges, not a Guttrz price.
What does a new roof cost in Louisville, Ohio?
Published 2026 cost guides for Ohio spread widely, and about $450 to $650 per square covers the middle of them for architectural shingles with a full tear-off. Treat that as a Northeast Ohio market range, not a Guttrz price. The table applies it to three roof sizes found around Louisville.
| Louisville house | Roof size | Northeast Ohio market range |
|---|---|---|
| Small ranch, simple gable | About 16 squares | $7,200 to $10,400 |
| Split-level or larger ranch with garage | About 24 squares | $10,800 to $15,600 |
| Two-story or steep older home | About 32 squares | $14,400 to $20,800 |
Ranges that wide are little use for budgeting. Two houses with the same floor plan can sit at opposite ends once pitch, layers and decking are counted.
What is a roofing square?
Roofers measure in squares, and each square is 100 square feet of roof surface. Roof area is always larger than floor area, because the roof slopes, overhangs the walls and usually covers the garage and porch too. A 1,400 square foot ranch with an attached garage can measure 20 squares or more.
What drives the price of a new roof up or down?
- Size. More squares means more shingles, more underlayment and more hours.
- Pitch. Up to roughly a 6/12 pitch, a roofer can walk the surface. Above about 8/12 it is steep work that needs roof jacks, harness anchors and more time for every bundle carried up.
- Layers. A second layer of old shingles doubles the tear-off labor and the weight in the dumpster. Two layers is the most the model building code allows, so a roof that already has two must be stripped.
- Decking. The wood stays hidden until the old shingles are stripped. Soft plywood or split planks have to be replaced before anything new is nailed to them. A fair quote states up front how replaced decking is priced.
- Details. Chimneys, skylights, dormers, valleys and wall joints each need flashing cut and fitted by hand. A plain gable roof has almost none.
- Access. The dumpster and the shingle delivery need somewhere to sit. A wide ranch driveway is easy. A narrow lot served by a rear court takes more carrying.
What does that mean for houses in Louisville?
The city's housing falls into three rough groups, and each tends to price differently per square.
1950s to 1970s ranches and split-levels. Close to half of Louisville's homes date from these three decades by census estimate. Low pitch, few details and a driveway next to the eave put them toward the low end of any per-square range. A hidden second layer is the usual surprise. The mid-century ranch streets page has more.
Older houses near downtown. Steeper roofs, dormers, tall chimneys and plank decking push toward the high end, and tight lots slow the tear-off.
Newer two-story homes. The pitch is moderate but the roof is big, cut up with hips and valleys, and two floors off the ground.
How does the written quote work?
The owner measures the roof at a free roof inspection, counts the layers, checks the deck from the attic and photographs every detail. You then get one flat number in writing with the scope spelled out line by line. That number holds for a year. There is no discount for signing the same day.
How do you compare two roofing quotes?
Line them up by scope, not by the bottom line. Check that both include a full tear-off instead of a layover, synthetic underlayment, ice and water shield at the eaves and valleys, new drip edge, new flashing and a ridge vent. Look for the permit, the dumpster and the decking terms. The cheaper quote is often the one that left something out. The shingles page explains the materials named on a quote.
Roof cost questions from Louisville homeowners
Why is there no Guttrz price list on this page?
Because a price that ignores pitch, layers and decking would be wrong for most houses. The figures shown are Northeast Ohio market ranges for comparison only. Your actual price is one flat written number after the owner has measured and photographed your roof.
Is the lowest price per square the best deal?
Only if the scope is the same. A low per-square figure can hide a layover instead of a tear-off, felt instead of synthetic underlayment, or reused flashing. Compare what is written on each quote before comparing totals.
Does a second layer of shingles change the cost?
Yes. Both layers have to come off, which means more labor and more dumpster weight. The layer count is checked at the gable edge during the inspection, so it is already in the quote and not a surprise on install day.
If I wait for spring, does my Louisville quote change?
Not if you already hold a written quote. The quoted price is good for a year from the day it is written, so an inspection in winter locks the number for a spring install.
Related pages
Want a real number for your own roof?
It takes one free visit. The owner measures, and the flat written quote that follows is good for a year.